Probably yes. Another test: could you try to set your Mesh complexity slider ALL THE WAY to the right ? With our mesh enabled or disabled, and see any differences ?
Umberto I just finished the tests and here are the results.
1st Test with FSDT Mesh.bgl installed
Mesh Complexity 100
Mesh Resolution 10m
Results: Really bad texture bleed thru the whole airport, mostly on runways on the western side (18L/R), the UPS area, the north entrance area, middle of the runways on the eastside (17L/C/R) and Delta Hanger area, south entrance.
2nd Test with FSDT Mesh.bgl removed from scenery folder
Mesh Complexity 100
Mesh Resolution 10m
Results: Much better with very minimal texture bleed, however there are some of the grassy areas in between the taxiways and other areas that kind of flash a little bit. Almost like the underlying ground textures want to come thru, but never make it so they just highlight themselves a little bit. Also this setting seemed to have cleared up the FSDT Van and Tug that drive around Terminal D. Prior to this setting the van and the tug would drive around half way under the ground texture.
A few other observations on Mesh Complexity 100 and Mesh Res 10m. There seems to be a few slight drop off points near the north side of Terminal A and B. In this same area it seems the some of the taxiway lines are not matched up exactly and there is a slight line that extends from the same point at Terminal B east to Terminal A. I also found a seam of bleed thru by runway 36R. I attached a few pics of these areas for you to take a look at but the 2nd test seems to be the best setting yet with only a few minor bleeds and flashes.
BTW, there are some funny things going on with the PAPI's on 36L/R and 35L/C/R where the lights dont seem to jive with the approach and sometime rather than showing white/white/red/red will be red/red/white/red and other combinations. I haven't noticed this on the runways facing south, just the ones facing north. I will start another thread on this later so as to keep to one item at a time since the bleeding is more of a concern to me at the moment.
Anyways, I hope these tested helped. I will probably try a few more with different a/c just to make sure it wasn't a fluke. If it was a fluke and other a/c give different results I will post back, but that shouldn't make any difference.
I will probably be going to be soon since its 5am here in Dallas, so if you need more info I will be back in a few hours. Let me know however if you want me to test any new mesh or flattens.
Regards,
Sean