« previous next »
Pages: [1]

Author Topic: Plane skimming across the ground  (Read 2490 times)

Wildrob409

  • Newbie
  • *
  • Posts: 2
Plane skimming across the ground
« on: January 09, 2019, 02:41:13 pm »
Hi All
Need help to find out why when I load GSX and do the airport it will work ok but when i go back into FSX and edited the airport again the plane skims across the ground.
Dose anyone know why and I can fix this please :)
Logged

virtuali

  • Administrator
  • Hero Member
  • *****
  • Posts: 51400
    • VIRTUALI Sagl
Re: Plane skimming across the ground
« Reply #1 on: January 09, 2019, 03:10:09 pm »
The problem is caused by your joystick which is not calibrated properly in the dead zone. Either calibrate the joystick dead zone correctly, or  remove all the joystick axes from the Slew events from the Control settings of the simulator
Logged

Wildrob409

  • Newbie
  • *
  • Posts: 2
Re: Plane skimming across the ground
« Reply #2 on: January 09, 2019, 08:55:28 pm »
Thank you it works great now
Logged

cirurgiao

  • Full Member
  • ***
  • Posts: 130
Re: Plane skimming across the ground
« Reply #3 on: December 23, 2022, 12:07:18 pm »
Hi, Umberto. You sent me this link after my P3Dv5 GSX issues topic.
I went to my controls but couldn't find any Slew attached to my joystick. Can you clarify me about that?
Tks
Logged
Eduardo Passos
Win10 64bit/P3Dv4.5/I10940X@4.2/GeForce RTX2080TI/128GB Corsair DDR

virtuali

  • Administrator
  • Hero Member
  • *****
  • Posts: 51400
    • VIRTUALI Sagl
Re: Plane skimming across the ground
« Reply #4 on: December 27, 2022, 11:43:28 am »
Quote from: cirurgiao on December 23, 2022, 12:07:18 pm
I went to my controls but couldn't find any Slew attached to my joystick.

The most common case if Slew axes assigned to another joystick, one you don't use but might still appear as a joystick. Check all joystick devices, and be sure no Slew axes are assigned to any of them, and be sure the controls page is set to "Slew" mode.
Logged
Pages: [1]
« previous next »