Author Topic: Double taxiway markings & signs / Jetbridges don't line up with Jetways  (Read 3639 times)

bhorv67

  • Full Member
  • ***
  • Posts: 173
I usually run Live Update each time before I fly and it appeared that I had all latest files. I hadn't flown into CYVR for a while, but when I did today, I noticed there are double taxiway lines & signs, and a lot of the jetbridges don't line up with the jetways.

After the flight I ran live update again, to which a lot of files were updated for CYVR, I'll check again and see if what was updated fixed the issue.

bhorv67

  • Full Member
  • ***
  • Posts: 173
Re: Double taxiway markings & signs / Jetbridges don't line up with Jetways
« Reply #1 on: November 18, 2019, 02:26:35 pm »
I believe I have resolved this issue by raising the library priority.


Dave_YVR

  • Beta tester
  • Hero Member
  • *****
  • Posts: 803
Re: Double taxiway markings & signs / Jetbridges don't line up with Jetways
« Reply #2 on: November 18, 2019, 10:39:53 pm »
 If you use ORBX, be sure have your library insertion points set correctly. Common for people not set them at all and then have layering issues throughout their sim. Once it's set, you shouldn't have to mess with layers again.