Hi,
While my actual cases concerns only Geneva (for the moment?), an eventual answer to this could well be used elsewhere too, hence why my choice of "General Discussion".
My question is rather simple (the answer maybe not so much). Is there a way I can block off the entire path I highlighted in red to certain types of AI aircraft, notably the widebodies? Widebody jets are not allowed to use said path because it's just too tight for anything larger than a 757 to get in there.
In real life, when a widebody parks at positions going from 14 to 19 (the large parkings along the blue path in my image), they always go in and out of Link 5 (the blue path, with the opposite arrows next to one another).
However, in P3D, they keep using the red path whenever they can.
https://c2.staticflickr.com/2/1952/44923145462_c698e50555_o.jpgNarrowbody jets have no such restrictions in real life and will use both paths when necessary.
I also know forcing widebody jets to only use the blue path may very well cause conflicts with other jets but I'm fine with that. P3D has no ground controller aware of every AI traffic and the paths they (will) take.
I can remove conflicting aircrafts with Traffic Explorer (from the P3D SDK, TrafficToolbox.dll) if necessary.
I tried to resize taxiways, no luck. I don't want to cut off anything in the afcad as narrowbody jets can take both paths as pointed out above.
Open to suggestions.