Gsx2 error the addon Unknow is causing........

[Joeblack]

Hi to all
Please can you help me.?
After installation GSX ver 2 I have always this error when I boarding the  passengers.... :
The addon unknow is causing couatl scripting engine to restart......

I must read this post?
http://www.fsdreamteam.com/forum/index.php/topic,18600.0.html
This is the same of my error?
thanks in advanced

[virtuali]

It's not nearly the same as that thread.

Your error is totally different and, you should post the error log details, the one GSX asked to open when you say the message you reported here.

[Joeblack]

It's not nearly the same as that thread.

Your error is totally different and, you should post the error log details, the one GSX asked to open when you say the message you reported here.

Thanks Umberto
This afterternoon I will post the error log
Regards
Giosuè

[Joeblack]

It's not nearly the same as that thread.

Your error is totally different and, you should post the error log details, the one GSX asked to open when you say the message you reported here.

Hi Umberto
I attacked my file error....
thanks
Giosue

[Joeblack]

It's not nearly the same as that thread.

Your error is totally different and, you should post the error log details, the one GSX asked to open when you say the message you reported here.

Hi Umberto
I attacked my file error....this error is very annoying during the simulation.....
Regards
thanks again
Giosue

Hi Umberto
Any info of My log error.........I can’t use GSX because this error is very annoying during the simulation

[virtuali]

Your error is clearly a bug in the scenery AFCAD, like unconnected parkings, orphaned parkings, overlapping nodes, not close paths, etc. I'm sure if you open the AFCAD with ADE, and run it through the "Fault Finder" tool, it will find some errors. Better report it to the scenery developer.

[Joeblack]

Your error is clearly a bug in the scenery AFCAD, like unconnected parkings, orphaned parkings, overlapping nodes, not close paths, etc. I'm sure if you open the AFCAD with ADE, and run it through the "Fault Finder" tool, it will find some errors. Better report it to the scenery developer.

Thanks Umberto
So My problems is genereted from some scenerys of My P3D and not from GSX!
Now My questions is......why with old version of GSX I did’t have these problems?
Only after installation of level2 I have always error message.......can you tell me?
can you explain me inside my flie.log which scenerys causing errors ?
thanks again
regards
giosue

[virtuali]

The error is caused by the scenery, and it prevented the Passenger bus to find a route. We already had a Passenger bus, but it was empty. Not sure if we slightly changed the way it goes away, but still the error IS caused by the scenery, and I'm sure it doesn't happen elsewhere.

[Joeblack]

The error is caused by the scenery, and it prevented the Passenger bus to find a route. We already had a Passenger bus, but it was empty. Not sure if we slightly changed the way it goes away, but still the error IS caused by the scenery, and I'm sure it doesn't happen elsewhere.

Thanks Umberto for your o rofessionality towards your customers!
I will test gsx on other scenery......if i have the same problem I will inform you
Best Regards
Giosue