FSDreamTeam forum
Products Support => Las Vegas FSX/P3D => Topic started by: vivalasvegas on June 14, 2013, 05:00:08 am
-
Just completed a successful flight from KLAX to KLAS and selected GSX Gate D36 for Delta Airlines. Follow me car worked great and I followed SAFEDOCK straight in. I hit CTRL-J as usual and nothing happened! I loaded another flight and selected D36 and the jetway responded this time! Any ideas on what I did wrong?
Thanks for your help!
vivalasvegas
-
Most likely the same thing that happened to me... please check your aircraft.cfg section [exits], if there are entries in FSX format not FS9...
example: (skyspirit 767) - might be commented or not syntax is percent per second, 3 coordinates, type (0=main, 1=cargo)
[exits]
number_of_exits = 2
exit.0 = 0.10, 73.7,-6.0, 7.5, 0
exit.1 = 0.2, -33.0, 5.85, -6.0, 1
exit.2 = 0.10, 6.0, 1.0, 3.0, 0
exit.3 = 0.09 , 6.0, 1.0, 3.0, 0
Older FS9 configs are different
Regards
Torsten
-
Thanks for your help. I think this may be a rare glitch because jetway problems for me are uncommon. The aircraft I was using is specifically designed for FSX and has performed OK at this FSdreamteam airport and others. After doing a search on this forum it doesn't look like this is a very common issue. There may be nothing I can do to prevent this from happening periodically.
vivalasvegas
-
Thanks for your help. I think this may be a rare glitch because jetway problems for me are uncommon. The aircraft I was using is specifically designed for FSX and has performed OK at this FSdreamteam airport and others. After doing a search on this forum it doesn't look like this is a very common issue. There may be nothing I can do to prevent this from happening periodically.
vivalasvegas
This has happened to me at a few airports. What worked for me is to slew the aircraft a few feet back, and try again. Do this until it works. It usually doesn't take that much.
John