FSDreamTeam forum

Products Support => Vancouver CYVR support FSX/P3D => Topic started by: Peter1397 on April 27, 2013, 11:14:59 pm

Title: Flight starting in water when selecting Vancouver Intl.
Post by: Peter1397 on April 27, 2013, 11:14:59 pm

Whenever I start up a flight with Vancouver Intl, I am immediately placed in the water where I subsequently reload only to be put back.

Occasionally I will start on the runway but this does not happen very often.

I have uninstalled and re-installed.

I did notice that while selecting the airport I am  switched immediately to "Vancouver Intl SPB", which I assume stand for seaplane base.

Help would be greatly appreciated.

Title: Re: Flight starting in water when selecting Vancouver Intl.
Post by: virtuali on April 27, 2013, 11:21:30 pm

That's nothing related to FSDT CYVR, we don't have any "Vancouver SPB" airport in our AFCAD, you must have another AFCAD active, which is taking precedence. Pay attention which airport you are selecting, there might be doubles.