FSDreamTeam forum

FS9 support => Zurich scenery for FS9 => Topic started by: sq_a380 on November 01, 2007, 08:21:16 am

Title: Ground texture
Post by: sq_a380 on November 01, 2007, 08:21:16 am

Hi, I'm using the demo verion of Zurich 1.1 and I noticed that the ground textures only show up at certain angles, at other angles all I see are the FS9 default aprons.

Title: Re: Ground texture
Post by: Alessandro on November 01, 2007, 05:57:46 pm

The problem is very strange, the problem is on spot view?

Title: Re: Ground texture
Post by: sq_a380 on November 02, 2007, 02:25:42 am

It happens in every view, when viewed at the ground at certain angles. The buildings and the rest show up alright, only the ground.

Title: Re: Ground texture
Post by: abc on November 15, 2007, 10:07:42 am

same problem here  :(
Not only the fs9 default apron, but everything is covered with fs9 apron!
Like these screenshot http://www.ewdrenth.eu/upload/LSZH.jpg
On ground it's only 'grey desert' and in the air the 'correct' texture shows only from  a few angles and in spot view.

Regards

Bernt Stolle  Capt 767
 

Title: Re: Ground texture
Post by: Alessandro on November 15, 2007, 10:51:43 am

Quote from: bstolle on November 15, 2007, 10:07:42 am

same problem here  :(
Not only the fs9 default apron, but everything is covered with fs9 apron!
Like these screenshot http://www.ewdrenth.eu/upload/LSZH.jpg
On ground it's only 'grey desert' and in the air the 'correct' texture shows only from  a few angles and in spot view.

Regards

Bernt Stolle  Capt 767
 

The problem is caused from the absence of autogen. Try to move the autogen slider minimum to sparse.

Regards

Title: Re: Ground texture
Post by: abc on November 15, 2007, 02:38:25 pm

Thank you. It works  :)

Regards

Bernt Stolle  Capt 767