FSDreamTeam forum

Products Support => Geneva FSX/P3D => Topic started by: CMDC on November 29, 2012, 06:53:14 am

Title: Problem with missing building!!!
Post by: CMDC on November 29, 2012, 06:53:14 am

Hello!

Actually the only missing buildings are the houses in front of terminal and convention center! reinstalled 2 times already..same problem!
installer ver.: 1.4.2

Carlos

Title: Re: Problem with missing building!!!
Post by: virtuali on November 29, 2012, 07:36:46 am

Try this first.

- DOWNLOAD AND INSTALL the current Stand-Alone Addon Manager with the antivirus entirely OFF

- TURN OFF your antivirus. Don't just exit from its interface, but turn off the real time protection. Actual wording changes between products, however, it's the option to scan every file that gets open in real time, without user intervention.

- Don't launch FSX yet.

- Configure the antivirus to exclude the following files from scanning:

YourFSXFolder\bglmanx.dll
YourFSXFolder\fsdreamteam\Couatl\couatl.exe

YourFSXFolder it's usually C:\Program Files\Microsoft Games\Microsoft Flight Simulator X, if you installed it in the default folder.

- Now you can turn the antivirus back on, and launch FSX.

- Check you are seeing BOTH the "Addon Manager" menu AND the "Couatl powered products" menu under the "Addons" menu.

Title: Re: Problem with missing building!!!
Post by: CMDC on November 29, 2012, 03:06:03 pm

Hi!

Thanks for your response...already made this from previeous post and no joy,  made a picture for the problem, no third party afcad, remove all FS genesis mesh addon  everything works and look ok. except this!

Carlos

Title: Re: Problem with missing building!!!
Post by: virtuali on November 29, 2012, 03:11:53 pm

Quote from: CMDC on November 29, 2012, 03:06:03 pm

made a picture for the problem  , no third party afcad, remove all FS genesis mesh addon  everithing works an look ok except this!

Check you don't have the following enabled:

- Any "Compatibility" mode in the FSX.EXE Properties. Turn everything off on that page.

- "Transparency Antialiasing" ( or Adaptive Antialiasing ) enabled in the properties of your Video Card.

Title: Re: Problem with missing building!!!
Post by: CMDC on November 29, 2012, 07:05:54 pm

Quote from: virtuali on November 29, 2012, 03:11:53 pm

Quote from: CMDC on November 29, 2012, 03:06:03 pm

made a picture for the problem  , no third party afcad, remove all FS genesis mesh addon  everithing works an look ok except this!

Check you don't have the following enabled:


- Any "Compatibility" mode in the FSX.EXE Properties. Turn everything off on that page.



- "Transparency Antialiasing" ( or Adaptive Antialiasing ) enabled in the properties of your Video Card.

1)Everything is off

2)if you  mean Antialasing transparency multisampling :I have this disabled and
                 Antialasing transparency supersampling : 2x sparce grid supersampling, also turned off and no luck

Regards

Carlos

Title: Re: Problem with missing building!!!
Post by: philuxbown on December 14, 2012, 10:34:39 am

I had the same problem, I reseted the default values in the options display buildings and the buildings reapeared ! :) :) :)

Title: Re: Problem with missing building!!!
Post by: CMDC on December 23, 2012, 11:40:21 pm

Hi :)

Thanks.. but Where I can Find That option?  ???


 Merry Christmas

Carlos