FSDreamTeam forum

Products Support => Los Angeles support FSX/P3D => Topic started by: fenice19 on September 25, 2012, 11:40:45 am

Title: lax rwls missed and other
Post by: fenice19 on September 25, 2012, 11:40:45 am

Hi, I've just purchased LAX but I'can't see rwsl at day/disk or night.
I've cross the runaway 6R simulating a runaway incursion during a takoff but nothing happened ( red or other red signal to comand a stop)
Only RW ending red light seems to be active.
PAPI light sometimes ( in the night) are off. If i restart the scenery they reappear again.
I'm using aerosoft US cityes los angeles and i've disabled it's lax.bgl module.
but the same problem happened without us cityes

Title: Re: lax rwls missed and other
Post by: virtuali on September 25, 2012, 01:51:06 pm

The custom runway lights and papi are not in the scenery, but handled by the Couatl program with a script so, they don't depend in any way from other sceneries. If you had all buildings, it means the Couatl program for KLAX was running fine. Can you describe some steps to reproduce the problem ?

Title: Re: lax rwls missed and other (solved)
Post by: fenice19 on September 25, 2012, 11:32:12 pm

Sorry, i've used a bad taxiway.
In the correct position red light are lit during a rw incursion.