FSDreamTeam forum

Products Support => Dallas FSX/P3D => Topic started by: westoverfd17 on February 28, 2012, 07:06:59 am

Title: Sunken Buildings Near Sky Train
Post by: westoverfd17 on February 28, 2012, 07:06:59 am

I have redone my pc and when I installed DFW I have some of the buildings around sky train are showing up partially below ground, all I have for sceneries are all FSdreamteam and 2 Flytampa sceneries installed no mesh. Any ideas? Thanks  Also tried using new downloader for addon manger still no luck.

Title: Re: Sunken Buildings Near Sky Train
Post by: virtuali on February 28, 2012, 11:56:30 am

Define "partially". If it's just a few centimeters, that's normal. If it's much more, than it's not. Also, have you set the Mesh sliders as suggested in the KDFW manual, on the "Design notes" page ?

Title: Re: Sunken Buildings Near Sky Train
Post by: westoverfd17 on February 28, 2012, 02:08:50 pm

Only the very top of the buildings are showing, the gates don't connect to the buildings just left in the air.  I have treid re-install and have mesh settings adjusted right and still nothing. All other scenries are working fine. having problem with all the buildings at or near Gate A23.

Title: Re: Sunken Buildings Near Sky Train
Post by: virtuali on February 28, 2012, 02:28:49 pm

Try to install the current version of the Stand-Alone Addon Manager for FSX after the scenery.

Title: Re: Sunken Buildings Near Sky Train
Post by: westoverfd17 on February 28, 2012, 02:48:30 pm

Tried that still nothing.

Title: Re: Sunken Buildings Near Sky Train
Post by: virtuali on February 28, 2012, 09:45:58 pm

Then the problem must have been caused by another scenery in conflict, try to use the free FSX Airport Scanner program to check if you have duplicates AFCADs for KDFW.