FSDreamTeam forum

Products Support => GSX Support MSFS => Topic started by: jakecminihan on March 09, 2024, 03:31:31 pm

Title: Setting different walking paths for each door
Post by: jakecminihan on March 09, 2024, 03:31:31 pm

Hi!

I'm looking to set up a profile for an airport where they board and deboard both via the jetway and the rear door using stairs. PAX from the rear then walk to the terminal. If I try and set up passenger waypoints, I don't get PAX deboarding from the back but instead just get the PAX deboarding from the front and walking to the rear. This is obviously something I've done wrong, but does anyone have any advice/know of any good YouTube videos showing this setup? Thanks :D

Title: Re: Setting different walking paths for each door
Post by: jakecminihan on March 09, 2024, 03:54:42 pm

Just to make this a bit more clear - I'm looking to see if it is possible (or would be possible in future) to board/deboard using both a jetway on the front and stairs at the back, which would require the ability to create different walking paths for each door.

Title: Re: Setting different walking paths for each door
Post by: Captain Kevin on March 09, 2024, 06:00:29 pm

As far as I know, this isn't presently possible.

Title: Re: Setting different walking paths for each door
Post by: virtuali on March 10, 2024, 11:56:33 pm

It's not currently possible but, some users suggested it so yes, it's a planned feature.