FSDreamTeam forum

Products Support => GSX Support MSFS => Topic started by: marknie on August 04, 2023, 06:43:00 pm

Title: Orbx PANC Jetways Not operating after landing
Post by: marknie on August 04, 2023, 06:43:00 pm

PMDG 737-700 MSFS 2020 PAJN to PANC Taxi to Gate C5 PANC Ask FMC or GSX to move jetway. It immediately says completed but never actually moves. Works if i start there but not if I land there.
Very strange? Tried the exception in the config as well. No luck.  Any ideas anyone? Im using ORBX PANC.  Thanks in advance

Mark Niebauer

Title: Re: Orbx PANC Jetways Not operating after landing
Post by: Justinthomas7 on August 05, 2023, 01:45:52 am

Try warping to a park and then trying.

This happened to me last night, I tried warping to the same spot (C4) and then it worked. 

Title: Re: Orbx PANC Jetways Not operating after landing
Post by: marknie on August 05, 2023, 07:05:36 am

Thanks for the help. Tried that. didnt work

Title: Re: Orbx PANC Jetways Not operating after landing
Post by: virtuali on August 14, 2023, 02:29:59 pm

First, be sure you disabled the GSX Jetway replacement files for that 3rd party airport, which you are supposed to do, as explained in the GSX Manual, Page 7

If you sure GSX jetways are not in use, GSX doesn't have ANY control over if a jetway works or not. GSX doesn't move, control or affect jetways, it only sends a command to the sim to toggle the jetway but, whether it would work or not, it depends only by your parking positions in relationship to the jetway, the airplane used, and the jetway model itself.