FSDreamTeam forum

Products Support => GSX Support MSFS => Topic started by: yorkjimenez on September 19, 2022, 05:41:43 pm

Title: Help with Airport editor
Post by: yorkjimenez on September 19, 2022, 05:41:43 pm

Good morning Umberto, is there a way to move objects faster when editing an airport, especially when you have to move the marshaller to the correct position and it is located far away, even using the Shift+ <> command, ˄ ˅ this It takes a long time and even more when there are airports with many ramps or boarding gates.
I would greatly appreciate your help.

Title: Re: Help with Airport editor
Post by: virtuali on September 20, 2022, 10:19:28 am

Please define "far away", is it's really too far that even using Shift it take a long time, that's usually an indication something's wrong with the scenery, perhaps the wrong .BGL has been read.

Title: Re: Help with Airport editor
Post by: yorkjimenez on September 20, 2022, 10:21:30 pm

thanks and how can I make this correct and read the correct BGL

Title: Re: Help with Airport editor
Post by: Flightdoc on September 21, 2022, 05:53:49 am

I was editing CYHZ today and every marshaller was placed in the terminal by default so it was minimum 15 keypresses using SHF arrow to get them out of the terminal and at the right spacing. Are yours further away than that?

Title: Re: Help with Airport editor
Post by: yorkjimenez on September 21, 2022, 08:27:20 pm

It has taken me more than 5 minutes to relocate the marshaller, but this only happens in airports purchased in the marketplace and they are not in the community folder, and inside there are no BGL files, there are other different ones