FSDreamTeam forum

Products Support => GSX Support FSX/P3D => Topic started by: Wildrob409 on January 09, 2019, 02:41:13 pm

Title: Plane skimming across the ground
Post by: Wildrob409 on January 09, 2019, 02:41:13 pm

Hi All
Need help to find out why when I load GSX and do the airport it will work ok but when i go back into FSX and edited the airport again the plane skims across the ground.
Dose anyone know why and I can fix this please :)

Title: Re: Plane skimming across the ground
Post by: virtuali on January 09, 2019, 03:10:09 pm

The problem is caused by your joystick which is not calibrated properly in the dead zone. Either calibrate the joystick dead zone correctly, or  remove all the joystick axes from the Slew events from the Control settings of the simulator

Title: Re: Plane skimming across the ground
Post by: Wildrob409 on January 09, 2019, 08:55:28 pm

Thank you it works great now

Title: Re: Plane skimming across the ground
Post by: cirurgiao on December 23, 2022, 12:07:18 pm

Hi, Umberto. You sent me this link after my P3Dv5 GSX issues topic.
I went to my controls but couldn't find any Slew attached to my joystick. Can you clarify me about that?
Tks

Title: Re: Plane skimming across the ground
Post by: virtuali on December 27, 2022, 11:43:28 am

Quote from: cirurgiao on December 23, 2022, 12:07:18 pm

I went to my controls but couldn't find any Slew attached to my joystick.

The most common case if Slew axes assigned to another joystick, one you don't use but might still appear as a joystick. Check all joystick devices, and be sure no Slew axes are assigned to any of them, and be sure the controls page is set to "Slew" mode.