FSDreamTeam forum

Products Support => Los Angeles support FSX/P3D => Topic started by: Locarno1 on September 25, 2018, 03:48:49 pm

Title: Only half the airport showing, ground textures
Post by: Locarno1 on September 25, 2018, 03:48:49 pm

Hi FSDT,

I've just loaded up in KLAX after not using it for a while and have noticed that it's only showing half the airport.. It shows the full airport but only half of it with ground textures, the other half with the base map and no taxiway markings or runway markings. There's a few buildings but nothing else..

I have ORBX Southern California installed so this maybe causing the issues?

Regards,

Tristan

Title: Re: Only half the airport showing, ground textures
Post by: virtuali on September 25, 2018, 03:54:34 pm

Quote from: Locarno1 on September 25, 2018, 03:48:49 pm

I have ORBX Southern California installed so this maybe causing the issues?

Can you disable it to see if this is the case ?

Title: Re: Only half the airport showing, ground textures
Post by: Locarno1 on September 25, 2018, 10:26:52 pm

Quote from: virtuali on September 25, 2018, 03:54:34 pm

Quote from: Locarno1 on September 25, 2018, 03:48:49 pm

I have ORBX Southern California installed so this maybe causing the issues?

Can you disable it to see if this is the case ?

Umberto,

Thanks, when de-activating the ORBX region, the full airport shows..

Many thanks,

Title: Re: Only half the airport showing, ground textures
Post by: Locarno1 on September 29, 2018, 11:18:28 am

Hi FSDT,

Any other suggestions at all? I've also tried uninstalling, re-installing and updating Add-on Manager.

Many thanks,

Title: Re: Only half the airport showing, ground textures
Post by: Psybear on September 30, 2018, 12:00:03 am

I had the same issue a while back but If you go to the Orbx site they explain what to do, Sorry, but I misplaced the link.

Clayton

Title: Re: Only half the airport showing, ground textures
Post by: virtuali on September 30, 2018, 11:31:51 am

Quote from: Locarno1 on September 29, 2018, 11:18:28 am

Any other suggestions at all? I've also tried uninstalling, re-installing and updating Add-on Manager.

What would be the point of doing this, when  you already assessed the problem was caused by OrbX ?

Title: Re: Only half the airport showing, ground textures
Post by: antonmorse on June 11, 2019, 09:51:51 am

I know this post is a few months old, but during a re-install I've been searching for the same info & I thought it was worth posting the link to the Orbx solution here as it might be useful to others.

https://orbxsystems.com/forum/topic/107942-sca-compatibility-with-fsdreamteam-klax/?tab=comments#comment-971420

It explains how to deactivate some Orbx files that interfere with the FSDT KLAX and KLAS airports.