FSDreamTeam forum

Products Support => Hawaiian Airports support FSX/P3D => Topic started by: jcm3mia on August 07, 2014, 03:18:41 am

Title: PHLI elevation problems
Post by: jcm3mia on August 07, 2014, 03:18:41 am

I just purchased the Hawaii package. There seems to be an elevation issue in PHLI. The airport seems to be sunken into a bowl but parts of it are like 20 feet higher. I have an almost pristine setup except for 2 ORBX products; FTX Global base pack, ORBX FTX Global Vector and the Pilot's Global Mesh FTX compatible.

Do you have an idea what could be causing the altitude issue?

Joe

Title: Re:
Post by: Dave_YVR on August 07, 2014, 06:53:30 am

Have you run the global vector elevation correction since installing HLI?

Title: Re: PHLI elevation problems
Post by: jcm3mia on August 07, 2014, 04:02:57 pm

No, I have not. That software is new also and I haven't had a chance to read the pdf. Going to do it right now and get back to you. Thanks.

Title: Re: PHLI elevation problems
Post by: jcm3mia on August 07, 2014, 05:21:15 pm

I didn't realize it was ORBX that I needed to adjust, all's well now, thanks for the help.

Title: Re: PHLI elevation problems
Post by: stook2005 on February 17, 2015, 05:54:42 am

You should also get the following AFM - Aerodrome Flattening Meshes.  It fixed a few elevation issues caused by FS Global 2010 that ftx vector cannot fixed.


http://www.fly2pilots.com/cms/Ui/Pages/Products/MainPage.aspx?id=d3fca479-6c4c-465b-bd75-97445878ae48