« previous next »
Pages: [1]

Author Topic: No vehicles in GSX woth P3DV2  (Read 4767 times)

thejoe

  • Newbie
  • *
  • Posts: 4
No vehicles in GSX woth P3DV2
« on: December 04, 2013, 03:06:16 pm »
Since installing GSX to P3DV2, none of the ground vehicles are displayed. The processes still function (loading, boarding, pushback, etc.) just without vehicles. All this worked in FSX and P3DV1.4. Any suggestions?
Logged

virtuali

  • Administrator
  • Hero Member
  • *****
  • Posts: 51237
    • VIRTUALI Sagl
Re: No vehicles in GSX woth P3DV2
« Reply #1 on: December 04, 2013, 03:23:28 pm »
Do you use some kind of migration tool ? If yes, turn if off, because it might have fooled the installer to install files in the wrong folders.
Logged

thejoe

  • Newbie
  • *
  • Posts: 4
Re: No vehicles in GSX woth P3DV2
« Reply #2 on: December 04, 2013, 06:00:51 pm »
No migration tool. Used the new installer from the FSDT site. Where are the vehicle files located?
Logged

virtuali

  • Administrator
  • Hero Member
  • *****
  • Posts: 51237
    • VIRTUALI Sagl
Re: No vehicles in GSX woth P3DV2
« Reply #3 on: December 04, 2013, 09:55:13 pm »
Quote from: thejoe on December 04, 2013, 06:00:51 pm
No migration tool. Used the new installer from the FSDT site. Where are the vehicle files located?

If you use the installer, it will install them in the proper location. And, you should have seen some error if vehicles were missing so no, they are not probably missing.

Try to reset your graphic settings, by removing the Prepar3d.cfg file in the %APPDATA%\Lockheed Martin\Prepar3d v2 folder, perhaps you applied a tweak that shouldn't be applied in P3D.

It might also be a problem with the P3D shader cache. Try to rebuild it by removing the following folder:

%LOCALAPPDATA%\Lockheed Martin\Prepar3d v2\Shaders

And then start P3D. On the first launch, it will take a while for the scenery to appear, because the sim is rebuilding its shaders so, just wait and it should come up eventually.
Logged

thejoe

  • Newbie
  • *
  • Posts: 4
Re: No vehicles in GSX woth P3DV2
« Reply #4 on: December 08, 2013, 02:10:24 am »
I have deleted the shader cache and used the updater again but I have the same problem. No fuel, no pushback, no catering only tall container loader. Any other suggestions?
Logged

thejoe

  • Newbie
  • *
  • Posts: 4
Re: No vehicles in GSX woth P3DV2
« Reply #5 on: December 08, 2013, 02:24:28 am »
All the vehicles are visible in P3dv1.4. Is there an issue with DX11 vs DX9?
Logged

virtuali

  • Administrator
  • Hero Member
  • *****
  • Posts: 51237
    • VIRTUALI Sagl
Re: No vehicles in GSX woth P3DV2
« Reply #6 on: December 08, 2013, 12:47:29 pm »
Quote from: thejoe on December 08, 2013, 02:24:28 am
All the vehicles are visible in P3dv1.4. Is there an issue with DX11 vs DX9?

There are no issue at all with GSX in P3D and DX11, GSX is fully compliant with P3D V2 and DX11 and it's has been tested to be like that, and everybody is using it normally.

Try to enable Logging in the GSX "Troubleshooting" section of the GSX Settings menu, call up a service for vehicles that you don't see, then exit and post your Couatl.LOG file and a Couatl.ERR file, if you have one.
Logged
Pages: [1]
« previous next »