Stairs not lining up on QW757

[DominikB]

On the both the QW757 200and300, the 2nd entry door does not line up even tho the 3 directional pointer thing is lined up
Note on the 200 i have removed door 1 and 4 and service door 4 as well as door 1 on the 300 as i found these excessive to my taste

Sorry  this was meant to go in support my mistake

[virtuali]

Since the QW757 is internally supported, try to Reset the configuration, this will revert to the one that comes with GSX.

[DominikB]

How do I do this?

[virtuali]

There's a reset option in the airplane customization page.

[DominikB]

got it will see if it worked in a bit thanks

[DominikB]

still happening, removing doors shouldnt cause this to happen? I didnt change anything but removing doors

http://hostthenpost.org/uploads/5d203b33614612a3c112db2208e61a36.png

[virtuali]

You haven't said if it worked as soon as you reset the configuration, without touching anything. Yes, of course just removing a door shouldn't cause this, but I would need to know if the supplied configuration works as is.

[DominikB]

sorry works fine with default on 200 and 300

[virtuali]

Please explain better: it's working normally as soon as you reset, then it stops working as soon as you start modifying it ?

[DominikB]

Reset works fine,
on -200 I set door 1 and 4 to no door and rear service to no door then what the picture shows happens
on -300 i removed door 1 and same occurs only on door 2 door 4 works normal

[DominikB]

this occurred with default setting after reset:

http://hostthenpost.org/uploads/9bcabdab3f2cceac0e2fbe9cf0d64f42.png

[virtuali]

Reset works fine,

this occurred with default setting after reset:

So, which one is true now ?

[DominikB]

the second one now, seems to be an issue with the 2nd door maybe?