Sir,
I apologize if is described somewere else but i have been googling and I could not find a solution.
the issue : floating and under basment jetway weels, erroneous placment of jetway onto the plane, only the front airplane weel in rare occasion vibrate as if it was not placed 'on ground' (this last tested only with QW 752)
This issue happen when I use:
- Geneva APT for fsx
- Slightly on Zurich APT for fsx
and Not on Milano Malpensa APT Malpensa SimGiant
and Not on Cloud9 Rome APT
Airplane models used :
- QW 752
- Pmdg MD11
- Fl1-LVD 763er
Jetway tested :
- Heavy
- Medium
- Small
Add on installed
(scenary related)
- Gex, Fex2,Utx, Landclass (for all of them all the world is installed on fsx but only europe is enabled)
(Traffic related)
UT trafficX II sp1 (+airound and supertrafficboard)
Please someone can teach me the correct sequence on the scenary.cfg?
ty very much for help.
Picture 1: Jetway weels under basment (curiosity : that tube is extended by itself by default and no plane is docked at it; in transparency Alitalia MD11 as per Pic4)
Picture 2: Too High and don't center door (L/R)
Picture 3: Jetway structural weels & service stairs are flying, front Airplane weel is 'bumping' Jetwaytube not centered and too high
Picture 4: Jetway not perfectly centered on the door, flying Jetway external service stairs and structural weels.