« previous next »
Pages: [1]

Author Topic: Double Jetways?  (Read 891 times)

John Hampton

  • Newbie
  • *
  • Posts: 8
Double Jetways?
« on: July 23, 2023, 08:17:28 pm »
This is a new one for me. I have Fly Tampa TNCM installed again after a long while. I had it installed in the past before and never had this issue. It seems the SODE jetways are attached to the ends of the jetways that come with the scenery. I am sorry if this has been covered before in the past. I'll take a link to the OP with the fix if it's out there.

Thx in advance

https://i.imgur.com/kZDHWiF.png

« Last Edit: August 02, 2023, 12:47:53 pm by virtuali »
Logged

Captain Kevin

  • Beta tester
  • Hero Member
  • *****
  • Posts: 1886
  • Captain Kevin
    • Captain Kevin
Re: Double Jetways?
« Reply #1 on: July 23, 2023, 10:07:08 pm »
As far as I can see, there isn't an issue. The bridge that goes over the road is just a walkway to get from the terminal over to the other side of the road. That part doesn't move. The actual movable jetway portion itself is the part that's attached to the end of the bridge, where the gate numbers are.
Logged
Captain Kevin

virtuali

  • Administrator
  • Hero Member
  • *****
  • Posts: 51439
    • VIRTUALI Sagl
Re: Double Jetways?
« Reply #2 on: August 02, 2023, 12:49:23 pm »
In general, whenever you see a problem with a scenery jetway ( which as far I can see, is not even a problem in this case ), it doesn't have anything to do with GSX, since GSX on FSX/P3D never replaces 3rd party jetways automatically and you need to go through a specific procedure if you want to do that.

And, jetways in your screenshots are clearly not from GSX either.
Logged
Pages: [1]
« previous next »