Jetway problem in LEBL

[Hossi]

Hi,
after the installation of LEBL I noticed that the Jetways have no shore power connection.
Therefore I have the Jetways 224 to 244 changed to GSX Jetways.
Unfortunately, this does not look good the Jetway float  above the apron. I have not had
such a problem problem yet. Why is this the case in LEBL? The AddOn is SimWing Barcelona.
Is there any way to change something, that it is possible the Jetways to change?
 Ciao Horst

[doksas]

I have problem like this in LIPZ (RFScenerybuilding) but jetays lie on the ground, when restart and reload couatl jetwas are in normal height, i dont know how to fix it.

[srcooke]

A known issue first raised in May 2020 where it initially affected adev5 afcads. Now a more widespread problem following the GSX Pro release.

Acknowledged by Umberto, nothing we can do except await a fix ( http://www.fsdreamteam.com/forum/index.php/topic,28100.msg183996.html#msg183996 )

[Hossi]

I have found a solution to the problem.
The Jetway BGL file from the Sceney folder set to OFF. Then all jetways are gone and you
can now go to install with GSX every parking position a GSX Jetway
This is how it works.
But this has a disadvantage, it is connected with a lot of work, because
Barcelona is not a small airport. With terminals 1 and 2 this airport has about 80 parking
positions with jetways which all must be set up.
The day is filled with office work concerning jetways set up at the airport Barcelona
At the the Moment I am in Quarantäne because of Covid19, so I have time to that work.

Best Regards
Ciao
horst

[srcooke]

I have found a solution to the problem.
The Jetway BGL file from the Sceney folder set to OFF. Then all jetways are gone and you
can now go to install with GSX every parking position a GSX Jetway
This is how it works.

That is fine on initial load, wait until you arrive at LEBL, the jetways will be sunk!

[Hossi]

yes, you are right. After landing at LEBL and taxing to Gate 234.
The Jetway was 10 m above ground.

Ciao Horst

[Hossi]

Now there is a solution to the problem. I got a great tip
from the FF forum. The Jetways against SODE replace Jetways.
The original file LEBL_LIB_Jetway.BGL set  to Off and now the Jetways
work with shore power connection and stand on the Apron.