Author Topic: Passengers wandering on the ramp  (Read 1035 times)

Mooze

  • Newbie
  • *
  • Posts: 33
Passengers wandering on the ramp
« on: August 30, 2022, 01:01:49 pm »
Hi,

I have an issue where most of the time when I lunch GSX services people pop up wandering on the ramp walking back and forth, they dont board the plane or anything they are just wandering around even when passengers boarding is in progress.

Cheers!

virtuali

  • Administrator
  • Hero Member
  • *****
  • Posts: 51443
    • VIRTUALI Sagl
Re: Passengers wandering on the ramp
« Reply #1 on: August 30, 2022, 01:16:34 pm »
Quote
I have an issue where most of the time when I lunch GSX services people pop up wandering on the ramp walking back and forth, they dont board the plane or anything they are just wandering around even when passengers boarding is in progress.

Please provide all the following information:

- the airport used, if it's not default, if you disabled it from jetway replacement in the GSX Config panel

- the gate used

- the airplane used

- the sequence of operations you did

Mooze

  • Newbie
  • *
  • Posts: 33
Re: Passengers wandering on the ramp
« Reply #2 on: August 30, 2022, 01:40:14 pm »
Happened at most airports I used default or payware .

3rd party paywares YPPH YSSY YPAD
3rd party freewares YSNF
default YMML

PMDG 738

no matter what sequence I use, even if I just request the jetway only I have them appearing, half the time they do half the time they dont.

virtuali

  • Administrator
  • Hero Member
  • *****
  • Posts: 51443
    • VIRTUALI Sagl
Re: Passengers wandering on the ramp
« Reply #3 on: August 30, 2022, 01:42:53 pm »
You haven't said you disabled all 3rd party airports in the GSX Config.

Please indicate the precise gate at default YMML, so I can check it. Did the jetway docked successfully ? GSX passengers won't start if the jetway hasn't docked.

Mooze

  • Newbie
  • *
  • Posts: 33
Re: Passengers wandering on the ramp
« Reply #4 on: August 30, 2022, 02:40:26 pm »
3rd party GSX AFCADs disabled, and YMML was the version from flightsim.to

YSCB was the default. Gate 10
YMML gate 6 the one I remember, but when this happens it does at any gate.