Bording problem with jetway

[CFG874]

Bording problem with jetway
Hello,
I have a problem refueling Aerosoft A319-A320.
Example: 134 Paxe Aircraft parking position:
Boarding over GSX with bus all normal people from 1..2..3..4..5..6..to 134, one after the other in about 10 minutes.

134 Paxe Aircraft on Gate with Jetway:
Boarding over GSX by leaps and bounds.
0 seconds later 10, seconds later 70,
after about 2 minutes 130 and when cargo on board 134 paxe end.
There are no intermediate values and the boarding noise only up to 10 people.
Even a new installation did not help, the FSD update was up to date.
Can you help me ?
Thanks in advance.
Sincerely, CFG874 Bernd

[CFG874]

Hello,

Since I don't get an answer to my question from fsdt either, I found out myself.
Here is the copy of the solution again:

I get in touch again after a long test and I think the problem is solved. So far, I have not received an answer to my request at FSDT Forum.
The evil lies in the GSX Level 2 Control Panel. The setting for P3dv4 was "Default Jetways are enabled".
After switching to "Default Jetways disabled by GSX", see photo, everything runs as normal, slowly cargo, fuel and boarding one passenger after the other and all values are correct even GW.
Here are some pictures from the test.
I think that solves the problem. Thank you again for your efforts. I'm just wondering that I'm the only one who had this problem.
So I wish you a happy Pentecost again
CFG874 Bernd

[Captain Kevin]

It wasn't clear if you had GSX Level 2 or not. Have a look at page 27 of the manual. With GSX Level 1, the passenger boarding is simulated based on timing. With GSX Level 2, the passengers are actually animated, so you can see the passengers boarding and deboarding the plane. That said, I don't think the passenger animations work with default jetways.