THis is about the only other shot I can think of that is needed otherwise....I'm confused.
That's what the problem is, this airplane has never been configured ( see the red warning about not having a config file ), so the door is in the wrong position.
When you see that pax icon, I do config the plane by hittng the Num 9 key which activates the ladder start icon,I move that to were the top of the ladder is then I hit the Num 9 key
again which triggers the ladder bottom icon, I then move the icon to where the base of the ladder is. (This all has been presented here before in screen shots ^). After I conclude with all this
I hit the Y key and as far as I can tell by the instructions, the door location has been configured. Isn't that the way I am supposed to do this? When I first hit the 3d edit key, the first icon
to appear is the Pax Icon, I cycle to the stair upper icon using the num 9 key, an so on and so forth till the coordinates of the ladder has been inputted to the GSX cfg file.
If there is a better way of doing this then I am interested in a better way to do this......
Edit: I don't see the red warning you mentioned, however, I did input the location of the stairs to GSX. The shot I showed you here is a new one that never was set up.