Adjusting loading stairs,,,end points ?

[teisco]

I cannot find how to get to the adjustment screen shown in screenshot below..when I chose embedded stairs and then enter the 3d editor I only get the screen with the main three arrows for forward, backward, up and down and side to side but not the end point adjustments that I need.

[virtuali]

I cannot find how to get to the adjustment screen shown in screenshot below..when I chose embedded stairs and then enter the 3d editor I only get the screen with the main three arrows for forward, backward, up and down and side to side but not the end point adjustments that I need.

If you enable the "Embedded Staircase" option, the Start and End point will appear as additional cycling objects, like additional doors, so you press NumPad 7 or NumPad 9 to cycle forward/backward through them.

[teisco]

Thanks,,,saved me again,,,glad your here.