GSX crashing using latest update and Aerosoft CRJ-900

[DVA12924]

I was able to run Live Update now and it did download 3 new files, but still having the issue where the Customize Airport Positions menu is not showing when loading sim into LFPG.

I CAN access the menu by going to another airport (T2GP - just off LFPG which seems to be a Taxi2Gate thing but is listed as an airport in P3D with T2G LFPG installed - but any airport can be selected) http://prntscr.com/oqg69l - this shows the "Customize airport positions" menu is there and usable outside of LFPG.

But if I then go back to LFPG, the menu is gone http://prntscr.com/oqg7sw and if I try to open to shift+F12 menu, it says there is no valid AFCAD file http://prntscr.com/oqg8m7

This is at gate J18 with Taxi2Gate LFPG. Also tried with 2 freeware AFCAD files and got the same results.

Aircraft was moved between airports using the Navigation/Go to airport menu in P3Dv4.5

[DVA12924]

I'm going to see if I can upgrade from Windows 7 to Windows 10 (since Windows 7 is outdated and MAY be the cause of the problem as GSX isn't being made for Windows 7 anymore), but I'll leave it updating while I sleep. I'll try to do a quick test before I have to go to work after I wake up. Please let me know if there is any progress in getting the issue resolved.

[virtuali]

Although you should update to Windows 10 in any case, this cannot possibly be the cause of the problem at LFPG.

I can reproduce it too, it's not the whole LFPG, it's just the areas farther from the airport center, so there's likely an issue with the GSX airport range setting.

[DVA12924]

It doesn't hurt to update Windows regardless lol

I'm glad you were able to reproduce the issue, that will help with getting it resolved. And you are correct that it is not the entire airport. I am able to update the main gates (like Terminal A), but the smaller gates on the outskirts of the airport for the regional jets is where I've been having the issue.

It it helps any, with the AFCAD file I attached in post 1, I was able to update gates J10 and J11 but the issue started on J12. Again, those spots are with the AFCAD in post 1, not the Taxi2Gate that I am using now. Hopefully that will help see where the boundaries are for any adjustments that may be needed.