Unwanted Jetways at FlyLogic Grenchnen LSZG-P3Dv4

[romair]

Hello Umberto

Hello

I have 2 SODE jetways and 3 cubes with single colors at Grenchen LSZG. CHPro and last Flylogic LSZG for P3D v4 is installed.

It looks like 3D design elements.

When I deactivate CHPro and deinstall the Flylogic LSZG addon I still have the non designed jetways and the cubes there. Therefore its not caused by

the Flylogic products. I also checked for doubled airport layouts but on the whole P3D drive there is no other LSZG layout file.

According to the basic colour of the jetways and the cubes it is probably a problem caused by SODE or GSX.

Screenshot is attached here

hope for help

regards Roger

[virtuali]

According to the basic colour of the jetways and the cubes it is probably a problem caused by SODE or GSX.

It would have been useful if you posted a screenshot of these cubes.

[romair]

Hello Umberto Thanks for investigation

Sending you a screenshot with the cubes, and ball and jetways.
On the same screenshot I have added the content of the GSX customize airport LSZG with parking 1/JS 
and a part of Virtuali-GSX-lszg-mjvx4q.ini

I tried to deinstall LSZG and I also change the jetways in the lszg-mjvx4q.ini to 0 but no success.

Hope for further help

regards Roger

[virtuali]

Hello Umberto Thanks for investigation

Sending you a screenshot with the cubes, and ball and jetways.

Ok, now it's clear. Those objects don't come with GSX. It's just that Grenchen happens to be the SAMPLE area for SODE so, every SODE install will add such objects at LSZG.

I see you posted the same question in the SODE forum, I don't remember where the XML file for these is located ( try %PROGRAMDATA%\12bpilot\SODE\XML ), but I'm sure you'll be replied with the correct answer.

[romair]

Good morning Umberto

Thanks for response. I will proceed to the SODE forum.

regards Roger