In your A318 aircraft.cfg, make sure the [exit] section is as follows...
[Exits]
number_of_exits = 4
exit.0 = 0.4, 30.0, -6.0, 2.0, 0
This will ensure the jetways connect correctly.
Below is the coordinates that align GSX with Tom's A318 aircraft. Just input these coordinates into the aircraft settings in GSX. If you have any issues or find better coordinates, please post them in the comments. Thank you.
----- A318 -----
Passenger Door #1
FSX Door #1
Name Main Exit
Position -2.25 9.08 3.40
Angle 2.00
Passenger Door #2
No Door
Passenger Door #3
No Door
Passenger Door #4
FSX Door #3
Name Emergency Exit
Position -1.98 9.50 3.74
Angle -10.00
Service Door #1
No Door
Service Door #2
FSX Door #4
Name Rear Service Door
Position 1.95 -9.50 3.76
Angle 10.00
Cargo Door #1
Door without open/close checks
Name Front Cargo Door
Position 1.06 6.24 1.96
Angle -25.00
ULD Code BELT
Cargo Door #2
Door without open/close checks
Name Rear Cargo Door
Position 0.80 -4.82 2.16
Angle 5.00
ULD Code BELT
Deicer In
Position 3.12 -0.02 3.38
Deicer Out
Position 16.44 -4.78 4.34
