Airbus A3X should both be belt loaders

[p3dx3]

I just started flying the Aerosoft Airbus, I've always watched some streams of the FSLabs Airbus. Both aircraft have AKE loaders, for FSLabs both are pallet loaders, and the AS Airbus, the rear is a pallet loader and the front belt, both should be belt loaders. In a future update would be nice to have this setting by default. Thanks.

[cowings1588]

You can do that, just change it too be belt loaders..

[Dave_YVR]

 GSX Customize aircraft and set it to your hearts content.

[p3dx3]

I know this but thought it would be nice for GSX to do this by default in the next update.

[virtuali]

AKE (known also as LD3-45) is the correct loader for an A320/321

https://en.wikipedia.org/wiki/Unit_load_device

So, we won't set it as default, since it's the proper loader to be used on such planes. Of course, if you don't like it, you can always configure it that way. That's what the configuration page is meant for.

[Dave_YVR]

 Not all carriers use the same configuration for loaders, some use belts both front and back, and others have LD45's front and back. Customize it once the way you like it and it's done! It only takes 30 seconds.

[Bruce Hamilton]

Can you customize that by carrier, or is it global?

[p3dx3]

My fault I was looking at only some carriers, a lot do use container loaders for the rear cargo door.