CS 757-200F

[Beedan]

Hello,

Does anyone know how to get GSX to load/ unload in and out of this cargo door? As I can't seem to get it to work.

https://i.gyazo.com/9c4e891c7e48d84a005d5377a2d8ee85.jpg

Thanks

[virtuali]

You must use the airplane configuration editor in GSX to create a config file for it, since it's not a model already internally supported. You might try to base the config from the passenger version, as explained here:

http://www.fsdreamteam.com/forum/index.php/topic,13045.msg97759.html#msg97759

[Beedan]

You must use the airplane configuration editor in GSX to create a config file for it, since it's not a model already internally supported. You might try to base the config from the passenger version, as explained here:

http://www.fsdreamteam.com/forum/index.php/topic,13045.msg97759.html#msg97759

Okay thanks, I tried that but when I went into 3D mode it activated slew mode and I couldn't get out of it?

[FLYFROMUTAH]

Does your CS 757 have it's own loader/unloader like the CS 777 for the main cargo door. I use CS's cargo loader for the main door and GSX for the two others. CS cargo loader animation works fine in GSX as a separate animation,sort of in parallel.

[Beedan]

Does your CS 757 have it's own loader/unloader like the CS 777 for the main cargo door. I use CS's cargo loader for the main door and GSX for the two others. CS cargo loader animation works fine in GSX as a separate animation,sort of in parallel.

Hello, Nope I don't think it does as it nevers shows when I have my engine shut down or that.

[FLYFROMUTAH]

It's in the CS animation panel, where you open the doors, and the rest like flight attendants, emergency slides, et al.

[virtuali]

Okay thanks, I tried that but when I went into 3D mode it activated slew mode and I couldn't get out of it?

At Page 29 of the GSX manual, the table named "Editor Keys summary" will tell you that the Y key, which by default is the Slew toggle, will Exit the Editor.

[Beedan]

Okay thanks, I tried that but when I went into 3D mode it activated slew mode and I couldn't get out of it?

At Page 29 of the GSX manual, the table named "Editor Keys summary" will tell you that the Y key, which by default is the Slew toggle, will Exit the Editor.

Thanks, I got it working