Products Support > Memphis KMEM Support FSX/P3D
Couatl Crash Loop at KMEM
Iced8383:
I preselected a gate at KMEM about 5 miles from the airport as I was landing today, and at about 400 feet Couatl threw up a message saying it crashed and asked if I wanted to see an error log, and if I wanted to restart Couatl. I restarted Couatl and got the same message again, and the cycle repeated itself 7-8 times until I was on the ground when Couatl started working again. This also happens to me when I load in at Memphis right off the bat without selecting GSX or anything. Attached is my couatl.err file from the crash repeat on approach.
virtuali:
We'll check it now.
mcox1986:
Did this bring any solution? I have the same issue while setting up the aircraft.
See Couatl panic log:
couatl v4.0 (build 4612)
panic log started on Sat Jan 22 12:49:57 2022
problem raised by addon <unknown>
Traceback (most recent call last):
File ".\common\modelCustomization.py", line 625, in setJetwayAirlineCode
File ".\common\modelCustomization.py", line 669, in getModelForCouatlType
File ".\common\modelCustomization.py", line 638, in getModelsForCouatlType
File ".\common\criticalsection.py", line 23, in _synchronized
File ".\common\modelCustomization.py", line 493, in _cache
File ".\common\modelCustomization.py", line 545, in _loadCacheFromPath
File ".\common\modelCustomization.py", line 603, in _loadLiveriesForModel
RuntimeError: this tasklet is taking too much time to execute
{}
virtuali:
--- Quote from: mcox1986 on January 22, 2022, 12:53:37 pm ---Did this bring any solution? I have the same issue while setting up the aircraft.
--- End quote ---
You mean you open the airplane configuration when parked at this airport ?
mcox1986:
No, sorry for misunderstanding.... question was if there has been any official solution for this? I deleted the P3D folder within couatl and will try again today if this already did bring a solution for me.
Navigation
[0] Message Index
[#] Next page
Go to full version