a320 plane config

[mike24]

Hello i am using project airbus a320 in p3d v3 when it comes to using gsx my main door works ok but my cargo doors did work in fsx but they dont work in p3d v3
 so what do i need to do in the config to bypass the cargo doors so even thou the cargo doors are not open they will still load so i can go through the process
thanks
mike 24 :

[virtuali]

There's no reason why the plane doors that worked in FSX wouldn't work in P3D, the commands are exactly the same so, before you configure GSX to ignore the door status (which is very simple anyway, just select the relevant option in the airplane configuration page), it's best if you try to understand why the doors don't open in P3D.

[mike24]

so as an example I just put remove where the cargo doors are
 
 
Project Airbus A320

« on: July 27, 2012, 12:48:26 PM »
Reply with quoteQuote 


[aircraft]
nosegear = 11.35
refueling = 1
absoluteheights = 1

[exit1]
pos = -1.85 11.45 3.35 5.0
code = 1
name = Main Exit

[exit2]
remove = 1

[exit3]
remove = 1

[exit4]
pos = -1.7 -13.15 3.75 -9.0
code = 3
name = Aft Exit

[service1]
flip = 1
code = 4
name = Fwd Catering

[service2]
flip = 4
code = 4
name = Aft Catering

[cargo1]
pos = 0.95 8.35 2.05 0.0
code = 2
name = Fwd Cargo Door
uldcode = BELT

[cargo2]
pos = 0.75 -6.15 2.19 0.0
code = 2
name = Rear Cargo Door
uldcode = AKH

[virtuali]

No, that's wrong. Removing a door will also remove the service it's associated with. You should instead set code = 0, so the door will be there, but the open/close status won't be checked.

But why you want to do it in the hard way, editing the GSX.CFG file by hand ? It's far easier using the airplane customization page, with the option "Door with no open/close checks"