Products Support > Memphis KMEM Support FSX/P3D

Traffic at KMEM

(1/2) > >>

jimstiles:
Just installed KMEM, looks great and as far as I can tell it's working good. Haven't taken any flights in or out as yet, just flew the trike around to check things out. I noticed that KMEM is not very busy with many AI as I expected, only a few at the terminal and a few FedEx planes parked in the FedEx area.

I parked the trike at the South end of the terminals and let the sim run for a bit to see if they would populate more AI but so far it's not showing as many as I would expect. I am in the same time zone as KMEM so it's about 3:30pm, should it be busier here at this time or do I need to install something to populate it more?

I have GSX installed and MyTraffic 6, not sure if I need to change a setting in them to include KMEM or not, if anyone is familiar with them, could you point me in the right direction?

Thanks, I've read the posts in the KMEM forum and, knock on wood, am not experiencing any of the problems some of the others are having. I'm usually the one with the bad luck but so far, this looks fantastic except for the lack of AI/FedEx planes which is probably something I need to do.

Jim

Bruce Hamilton:
Where is your airline slider set?  I had mine at 50% and the FedEx terminal was standing room only.

jimstiles:
I checked and had it set to 20, bumped it up to 40 and got a few more planes. Think I had it turned down to help with the fps but I left it at 40 for now to see how things go. I've been sitting on the apron now for over 30 minutes and only one Delta flight has taken off, no landings. Should it be busier than this or would this be normal for this time of day for KMEM?

Thanks

Bruce Hamilton:
I just checked the flight board for Memphis, and there aren't that many flights scheduled in or out during the day, and they don't list FedEx on that because they're freight. Only two or three arrivals or departures during most hours.

jimstiles:
Ok, well maybe it's working ok then, I'm going to take a flight from KLIT to KMEM in a bit.  I just tried to bring up the gsx menu using Ctrl/F12 but nothing comes up, did that change? I can't find any instruction files to read.

Thanks

Navigation

[0] Message Index

[#] Next page