Posky B757-200PF

[Pitter]

Just installed Posky B757-200PF into FSX. Add a gsx.cfg and start loading. Works well so far except that all main deck pallets are loading
into the cockpit.    I mean, the loader staff moved all main deck pallets to the front, even there is only space for one pallet.
attached is my cfg.  Any tips??



[aircraft]
nosegear = 17.45
refueling = 1
wingrootpos = 1.90 -0.97 0.00
wingtippos = 19.02 -4.67 0.00

[exit1]
pos = -1.85 19.65 0.98 5.00
code = 1

[cargo1]
pos = -1.85 13.45 0.80 0.00
code = 2
uldcode = PALLET6

[exit3]
remove = 1

[exit4]
remove = 1

[service1]
flip = 1
code = 3

[service2]
remove = 1

[cargo2]
pos = 0.95 -8.20 -0.69 0.00
code = 2
uldcode = BELT


tks, Peter

[virtuali]

Works well so far except that all main deck pallets are loading
into the cockpit.    I mean, the loader staff moved all main deck pallets to the front, even there is only space for one pallet.

I'm not sure to understand you. Are you saying the cargo loader position is wrong ? GSX position the loaders where you said the doors is located.

Or, do you mean you wanted to ALWAYS load 1 pallet ? That's not supported, GSX doesn't know anything about how many pallets will fit in a certain airplane. It will always generated a number of pallets changing from 1 to 5, depending on the estimated number of passengers on board, which is calculated starting from the weight of all loading stations.

[Pitter]

No, you did not understand.
I try to make it more clear: The main deck cargo door is close to the L1 door. That means, if you move the pallets (main deck) in, and then forward instead of moving aft, there is no space in the forward direction. Simple: the pallets must go to the rear instead forward. And that is what not happens.
They going all forward direction

Peter