Ifly 737-800 and exit 2 and 3

[thelaststand]

Hallo i just bought this great product but i can not use it. It keeps asking me to open exit 2 and 3. I tried modyfying the gsx.cfg like i saw here in the forum in remove=1 value. Nothing the same again. How can i open exits 2 and 3 actually. Is it possible? I use prepar3D and ifly prepar3d version. I have the latest update from gsx installed. Sorry for the stupid questions from a niewbie. Thanks in advance.

[maggi5]

Here's a link to download the all in one Gauge for the Ifly 737.

So you can open all doors.

I also have the ifly and it works well.

http://library.flight1.net/?did=352

[thelaststand]

Thank you so much my friend

[alexchard]

I have tried installing this All In One Doors gauge by following the instructions but I cannot get the gauge to show! Please can anyone help?

[cowings1588]

me too, wish there was how to video showing how to do it.. I followed the instructions but must be missing doing something because it doesn't show up either..

[unc1rlm]

I had the same problem. I used the version 2, don't work. I deleted v2 and used original not updated.  You should have 2 versions in the download. If you have already changed the config file, just put the zip version in the fsx module folder. Go to 2d panel and click on electrical aft button, and you should see the 4 gauges. Only 3 doors open, the maintenance button is for the engine cowling. I can't get the right rear door to open . If anyone reads this, and have figured this out, share   Hope this helps. youtube video:

Bob