problem with building and textures in p3d v2.4

[pablo636]

Hello,
This is the first time I install KLAX in p3d, I've installed also GSX KDFW, KFLL and KORD without any problems with the same installation procedures wrote here in the forum, and every time I have downloaded the latest installer before intall them in p3d.
This time something went wrong, but I cannot figured out what!
any help is appreciated


http://i.imgur.com/ze5KfXp.jpg

http://i.imgur.com/dQjI3pj.jpg

[virtuali]

This has been discussed many times on the forum, and it's a result of an incomplete P3D installation, and it's solved this way:

http://www.fsdreamteam.com/forum/index.php/topic,10084.msg79077.html#msg79077

[pablo636]

hello,
thnks for the reply, I've seen that post, but I supposed that is not my case. Anyway, I've check, and I can confirm that those files are installed, and I have the addon manager and couatl working fine, it show the products installed and those are active, klax too.

[virtuali]

Do you use the P3D Migration tool ? If yes, you must turn if off, and reinstall the scenery.

[pablo636]

no, I haven't used it to install your scenery as your installer are p3d v2 ready.
But, I don't know why, now the problem seems to be solved.
I start the sim on my default location to change the mesh complexity to 5m instead of 2m, and then switch to klax , and everything was fine, so I tried to change again the mesh slider to 2m, and is everything fine also with the mesh at 2m.
So, I don't know why now everything is working as it should!
Anyway, thanks!

Paolo